Seagate ST34371N 4.3GB SCSI 50 PIN 72K RPM 3.5 HDD 9C6001-010 / 9C6001010

Seagate ST34371N 4.3GB SCSI 50 PIN 72K RPM 3.5 HDD 9C6001-010 / 9C6001010
Seagate ST34371N 4.3GB SCSI 50 PIN 72K RPM 3.5 HDD 9C6001-010 / 9C6001010
Seagate ST34371N 4.3GB SCSI 50 PIN 72K RPM 3.5 HDD 9C6001-010 / 9C6001010

Seagate ST34371N 4.3GB SCSI 50 PIN 72K RPM 3.5 HDD 9C6001-010 / 9C6001010
SEAGATE ST34371N 4.3GB Ultra SCSI 50 PIN. 3.5 Internal Hard Drive – 9C6001-010. SOFTWARE, SCSI CARD, AND SCSI CABLE ARE NOT INCLUDED, BARE DRIVE ONLY!!! Barracuda 4LP drives combine magneto resistive (MR) heads, partial response/maximum likelihood (PRML) read channel electronics, embedded servo technology, and a SCSI-3 (Fast-20) interface to provide high performance, high capacity data storage for a variety of systems including engineering workstations, network servers, mainframes, and supercomputers. Fast-20 (also known as Ultra SCSI) is a negotiated transfer rate. This transfer rate will occur only if your host adapter also supports Fast-20 data transfer rates. This drive also operates at SCSI-1 and SCSI-2 data transfer rates for backward compatibility with non-Fast-20 capable SCSI host adapters. Single-ended or differential SCSI drivers and receivers. 8 bit and 16 bit I/O data bus models available. Asynchronous and synchronous data transfer protocol. Firmware downloadable via SCSI interface. Selectable even byte sector sizes from 180 to 4,096 bytes/sector. Programmable sector reallocation scheme. Flawed sector reallocation at format time. Programmable auto write and read reallocation. Reallocation of defects on command (Post format). 128 bit Reed-Solomon error correcting code. Sealed head and disc assembly. No preventative maintenance or adjustment required. Dedicated laser textured head landing zone. Embedded servo data rather than a separate servo data surface. Self diagnostics performed when power is applied to the drive. Zoned bit recording (ZBR). Vertical, horizontal, or top down mounting. Active IC terminators enabled by jumpers (N and W models only). 512 K byte data buffer. Hot plug compatibility (section 9.6.4.3 lists proper host connector needed) for WC and DC model drives. Level 2 is a factory installed option. Low audible noise for office environment. AVERAGE SECTORS PER TRACK. DISCS (3.5 in). INTERNAL TRANSFER RATE (mbits/sec). EXTERNAL TRANSFER RATE (mbyte/sec). Height (inches/mm): 1.0/25.4 Width (inches/mm): 4.00/101.6 Depth (inches/mm): 5.47/146 Weight (lbs/kg): 1.5/0.68. The item “Seagate ST34371N 4.3GB SCSI 50 PIN 72K RPM 3.5 HDD 9C6001-010 / 9C6001010″ is in sale since Tuesday, September 4, 2018. This item is in the category “Computers/Tablets & Networking\Drives, Storage & Blank Media\Hard Drives (HDD, SSD & NAS)\Internal Hard Disk Drives”. The seller is “ncd_inc” and is located in Santa Ana, California. This item can be shipped worldwide.
  • Model: ST34371N
  • Interface: Ultra SCSI
  • Type: 3.5″ Internal Hard Drive.
  • Rotation Speed: 7200RPM
  • MPN: 9C6001-010
  • Storage Capacity: 4.3GB
  • Brand: Seagate
  • Form Factor: 3.5 in

Seagate ST34371N 4.3GB SCSI 50 PIN 72K RPM 3.5 HDD 9C6001-010 / 9C6001010